4.Loosen the Hex Socket Screw (56), and raise the Bed (4) to the desired sanding position.
(See Figure I.)
5.Insert the Index Pins of the Table Support (36) into the Auxiliary (upper) Holes in the Bed (4). (See Figures G and I.)
6.Retighten the Hex Socket Screw (56). Check to make sure the Worktable (35) is not touching the Sanding Belt (10). (See Figure I.)
FIGURE I
AUXILIARY
MOUNTING HOLES
|
| KNOB (1) |
HEX SOCKET SCREW (56) |
|
|
|
| |
(NOT SHOWN) |
| TABLE SUPPORT (36) |
To Level The Worktable Assembly:
1.Place a combination square on the Worktable (35) so that the square also touches the Sanding Pad (27). (See Figure J.)
2.If the Worktable (35) is 90 degrees to the Sandpaper Pad (27), the combination square is flush on the Pad. (See Figure J.)
3.If the Worktable (35) is NOT 90 degrees to the Sandpaper Pad (27), loosen the Knob
(1) and tilt the Worktable until the combination square is flush with the Pad.
(See Figure J.)
4.Retighten the Knob (1) to secure the Worktable (35) in place. Then, attach the Scale Label (37) to the “0” degree mark on the Dust Collector (34).(See Figure J.)
COMBINATION SQUARE
(NOT INCLUDED)
WORKTABLE (35) FIGURE J
SCALE LABEL (37) | KNOB (1) |
SKU 38123 | For technical questions, please call | Page 12 |
