UNPACKING
When unpacking, check to make sure all parts listed in the Parts List on page 19 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
WARNING! 
Make sure the Power Switch of the Sander is in its “OFF” position, the Switch Key (21) is removed, and its Power Cord/Plug is un- plugged from the electrical outlet prior to performing any assembly.
To Secure The Sander Base Assembly To A Workbench:
1.The Sander must be secured before using. You may attach a large
2.Place the Sander in the desired location on the workbench.
3.Use the mounting holes located at the Sander Base (42) as a template to mark two drill holes in the workbench. Remove the Sander, and drill two 3/8” holes through the workbench. (See Figure E.)
4.Align the Sander Base (42) over the two holes in the workbench, and secure the Sander to the workbench using two 3/8” bolts and lock nuts (neither included). (See Figure E.)
DISC (30)
6” SANDPAPER PAD (27) | MOUNTING HOLE |
|
DISC GUARD (32) |
| FIGURE E |
|
| |
PAN HEAD SCREW (31) |
| |
To Mount The Sandpaper Pad And Disc Guard:
1.Locate the 6” Sandpaper Pad (27), and peel the backing off the Pad. (See Figure E.)
2.Align the perimeter of the Sandpaper Pad (27) over the Disc (30). When aligned, press the Sandpaper Pad firmly onto the Disc. (See Figure E.)
3.Attach the Disc Guard (32) over the lower portion of the Disc (30), using two Pan Head Screws (31). (See Figure E.)
To Mount The Table Assembly:
1.Locate the Table Support (36), mounting Hex Screws (6), Lock Washers (7), and Flat Washers (8). (See Figure F.)
SKU 38123 | For technical questions, please call | Page 9 |
