Harman DMS70 manual Front panel

Description

Front panel

Figure 1: Controls on the front panels of the DSR 70 Dual and Quattro receivers

The controls (2 and 3) and the LEDs (4 to 6) are the same for all channels.

NOTE

1 On/off button: This button is lit green when the receiver is switched on and ready for use. It is sufficient to switch off the receiver to switch off the DMS 70 system. Switching off the receiver switches off all transmitters connected to this receiver.

2 VOLUME potentiometer: This potentiometer allows continuous adjustment of the audio output level on this channel (10/10a). The Mixing Function means that this potentiometer also influences the sum output (9) on the DSR 70 Quattro.

3 CONNECT: This button has two functions:

￿Press briefly: to check the transmitters assigned to this channel.

￿Press and hold down (approximately 2 seconds): to assign a transmitter to a free channel or to register a transmitter on this channel.

4 LOW BATT. LED: This LED lights up when the batteries of the transmitter registered on this channel are flat. If the LED starts to flash red the battery will be flat within about one hour. Replace with new batteries as soon as possible.

5 STATUS LED: This LED lights up green if a registered transmitter is active on this channel and is ready for operation. The LED flashes green during the channel identification and channel assignment processes.

6 CLIP LED: This LED lights up red if the audio level on this channel is too high.

7 Antennas: Fixed transmitter and receiver antennas. The best transmission and reception performances are achieved when both antennas are pointing upwards in the "normal position" (see diagram on the title page).

DMS 70 Quattro/Dual 25