Harman DMS70 Identifying the channel and/or appliance, Use the identification function to check

Setting up

Identifying the channel and/or appliance		When delivered, the transmitters are preconfigured to channels 1 and 2 of the receiver.
		Use the identification function to check
		￿ the channel on the receiver assigned for a transmitter and
		￿ the connected transmitter for a channel on the receiver.
		Press Connect (16) briefly on the transmitter or the receiver.
		￿ The status LEDs (13) on the same channel of the transmitter and receiver flash
		green.
		This identification function can also be used during operation without causing any disturbance
		or interruption.
	NOTE
Assign the transmitter to a free channel or		The following instructions apply for the assignment of a free channel and for changing a
change the channel		channel.
		Actions 3 and 4 can be started from the transmitter and receiver. In this example, they are
		started from the receiver.

1)Pull the battery compartment cover (14 / 22) down and off the transmitter.

2)Switch on the transmitter and receiver.

3)Press Connect (3) on a free channel of the receiver and hold down until the status LED

(5)starts to flash after approximately 2 seconds.

￿You need to confirm with the transmitter within the next 30 seconds.

4)Hold down Connect (16) on the transmitter until the status LED (13) lights up green.

￿The status LEDs on the transmitter (13) and the receiver (5) light up green once assignment has been successful.

The actuated settings are saved. This means that you can simply continue using the DNS 70 system with the last-used settings (channel assignments) the next time you switch on.

NOTE

	Dual channel use is not possible with the DMS70 system.
	I.e. several transmitters can't be assigned to a single channel on the receiver. The LED on the
	connected transmitter lits green, the LED on the transmitter, which is not connected, flashes
NOTE	green. Please assign this transmitter to a free channel on the receiver.
	Take care that you do not use a channel twice.

Registering a new transmitter on the receiver

Start the registration process with the transmitter: Transmitter -> Receiver

1)Pull the battery compartment cover (14 / 22) down and off the transmitter.

2)Switch on the receiver.

3)Press and hold Connect (16) on the transmitter while pressing the on/off button(15) until the status LED (13) starts to flash.

￿Within the next 30 seconds, the status LED (13) flashes rapidly and you need to confirm with the receiver.

4)Hold down Connect (3) on a free channel of the receiver until the status LED (5) lights up green.

￿The status LEDs on the transmitter (13) and the receiver (5) light up green after successful registration.

34 DMS 70 Quattro/Dual