Setting up
You can also start this process from the receiver: Receiver
1)Pull the battery compartment cover (14 / 22) down and off the transmitter.
2)Switch on the receiver.
3)Press Connect (3) on a free channel of the receiver and hold down until the status LED
(5)starts to flash after approximately 2 seconds.
You need to confirm with the transmitter within the next 30 seconds.
4)Press and hold Connect (16) on the transmitter while pressing the on/off button(15) until the status LED (13) lights up green.
The status LEDs on the transmitter (13) and the receiver (5) light up green after successful registration.
Setting up the handheld transmitter | 1) | Switch on the handheld transmitter using the on/off button (15). |
| 2) | Switch on your PA system or amplifier. |
| 3) | Assign the handheld transmitter and receiver to a free channel. |
| 4) | Speak or sing into the microphone and watch the CLIP LED (6) on the receiver: |
|
| Set the GAIN switch (17) to "HIGH" under normal conditions. |
|
| If the CLIP LED lights up frequently or all the time when you sing loudly, the input |
|
| sensitivity of the transmitter is too high. Set the GAIN to "LOW". |
| 5) | Set the volume of the PA system or amplifier referring to the appropriate instruction |
|
| manual or by ear. |
After two minutes without radio contact with the receiver (receiver is OFF, power failure, outside range, etc) the connected transmitters switch off automatically.
NOTE
Setting up the bodypack transmitter | The bodypack transmitter DPT 70 has been designed for use with the CK 55 L, C 411 L, C | |
|
| 520 L, C 555 L, C 516 ML, C 518 ML, C 519 ML and CK 77 |
|
| If you wish to connect microphones from other manufacturers to the DPT 70, please note that |
|
| you may have to replace the existing connector of your microphone with a |
|
| connector. |
|
| Audio input pinout: |
|
| Pin 1: shield |
|
| Pin 2: audio inphase (+) |
|
| Pin 3: supply voltage |
|
| A 4V positive supply voltage for condenser microphones is available on pin 3. |
|
|
|
|
| There is no guarantee that the bodypack transmitter DPT 70 will work perfectly with products |
|
| from other manufacturers. Any damage that may result from such use is not covered by the |
|
| AKG warranty scheme. |
| ATTENTION |
|
Connecting a microphone
1)Remove the battery compartment cover (22).
2)Plug the mini XLR connector on the cable of your microphone into the audio input socket (19) on the bodypack transmitter.
3)Slide the slide cover (20) to the rear position and switch on the bodypack transmitter using the on/off switch (15).
4)Assign a free channel to the bodypack transmitter and receiver.
5)Speak or sing into the microphone.
6)Use the screwdriver integrated in the battery compartment cover to set the GAIN control
(23)to a position where the CLIP LED (6) on the receiver will flash occasionally.
7)Replace the battery compartment cover on the transmitter.
DMS 70 Quattro/Dual | 35 |
