Harman-Kardon AVR 354 Step Six Plug in AC Power, Step Seven Insert Batteries in Remote

INSTALLATION

AVR 354

Figure 32 – HDMI Monitor Output

Component Video: If the display does not have HDMI inputs, but does have component video inputs, connect the Component Video Monitor Outputs to the display (see Figure 33). As with HDMI connec- tions, the AVR 354 is capable of converting composite and S-video sources to the component video format, while upscaling the resolution to as high as 1080i, depending on the display’s capabilities. Unlike HDMI connections, component video connections do not enable the AVR 354 to detect the display’s capabilities and the appropriate resolution must be selected manually, as described in the Initial Setup section.

AVR 354

Figure 33 – Component Video Monitor Outputs

Composite/S-Video:If the video display does not have HDMI or component video inputs, connect the corresponding composite or S-video Monitor Output to the display. If available, S-video is preferred over composite video, and if used, the AVR 354 will convert composite video sources to S-video. See Figure 34.

AVR 354

Figure 34 – Composite and S-Video Monitor Outputs

Consult the manual for your TV to make sure you understand how to select the correct video input.

Step Six – Plug in AC Power

Having made all of your wiring connections, it is now time to plug each component’s AC power cord into a working outlet.

You may plug one device into the AC Switched Accessory Outlet on the rear of the AVR 354. See Figure 35. Make sure this device draws no more than 50 watts. The device should have its mechanical or master power switch turned on, and it will power on any time the AVR 354 is turned on. If the device has a clock or must always be on, do not plug it into this outlet.

AVR 354

Figure 35 – Switched AC Accessory Outlet

Before plugging the AVR 354’s AC Power Cord into an electrical outlet, make sure that the Master Power Switch on the front panel is popped out so that the word OFF appears on its top. Gently press the button to turn the switch off. This will prevent the possibility of damaging the AVR in case of a transient power surge.

The AVR 354 is equipped with a detachable power cord. It allows you to fully wire your system before installing the AVR, which may be required for some in-wall entertainment centers or custom applications. The male end of the cord should be plugged into an unswitched AC power outlet, and the female end should be plugged into the receptacle on the AVR 354’s rear panel. See Figure 36.

AVR 354

Figure 36 – AC Power Input

Step Seven – Insert Batteries in Remote

The AVR 354 remote control uses four AAA batteries, which are included.

To remove the battery cover located on the back of the remote, squeeze the tab and lift the cover.

Insert the batteries, as shown in Figure 37, making sure to observe the correct polarity.

30 30