Manuals / Brands / Personal Care / Mobility Aid / Harmar Mobility / Personal Care / Mobility Aid

Harmar Mobility AL500 ( RAISED UNTIL, MOTOR RATCHETING IS HEARD ), WITH THE PLATFORM FULLY RAISED, LIFT SHOULD HOLD WHEELCHAIR FIRMLY

1 36

Download 36 pages, 10.87 Mb

LIFT PREPARATION

AL010/050 and AL030 PIVOT POINT ADJUSTMENTS

			N
		IO
	NS
	STTE
JU
AD

The hinge points are equipped with tensioning washers. The amount of force required to move these parts is determined by the t e n s i o n o f t h e s e w a s h e r s . To adjust, simply loosen or tighten the bolt and nut located by w/ arrows. The tension is set at the factory and should need no adjustment . This is noted for reference only.

			N
		IO
	NS
	STTE
JU
AD

TENSION

ADJUST

Al030 HOLD DOWN ARM ADJUSTMENT

nuts

here

Loosen

arm Slide

Tighten

up	or

after

tube down adjustment

LIFT SHOULD HOLD WHEELCHAIR FIRMLYWITH THE PLATFORM FULLY RAISED( RAISED UNTILMOTOR RATCHETING IS HEARD )

Contents

Page UNPACKING THE LIFT WIRING THE VEHICLE 2BEGIN ROUTING THE VEHICLE HARNESS AT THE BATTERY Side mount Top mount VEHICLE HITCH AL123 AL125 hitch class bumper distance Bumper distance INSTALLATION Attach Lift to Hitch Post or Swing Away For AL030 ONLY CHAIR PREPARATION CHOOSING A LOCATION and MOUNTING THE DOCKING DEVICE PLATE Find approximate center of the chair DO NOTUSE SPACERS HERE Use existing holes where ever possible Drill as required SETTING DOCKING DEVICE HEIGHT Measure distance of mounting surface to ground Determine LIFT PREPARATION SETTING HOLD DOWN FOOT HEIGHT LIFT SHOULD HOLD WHEELCHAIR FIRMLY WITH THE PLATFORM FULLY RAISED ( RAISED UNTIL MOTOR RATCHETING IS HEARD ) FOR ADJUSTMENT PURPOSES, ALL PLATFORM COMPONENTS ARE SHIPPED LOOSE AND MUST BE FIRMLY TIGHTENED ONCE ADJUSTED BE SURE TO TIGHTEN ALL FASTENERS Page OPERATION General Operating Instructions: AL500, AL550 AL100, AL300 AL301XL Courtesy Note: Special Note: The AL100 LOADING THE POWER CHAIR Page UNLOADING THE POWER CHAIR LOADING A SCOOTER LOADING A POWER CHAIR 1 Insert Key and switch to "ON" position 2 Once platform has been lowered at least an Press down on Toggle switch momentarily to the ground LOADING THE WHEELCHAIR LOADING A POWER CHAIR Page MAINTENANCE: The lift does not operate The motor does not lift the platform completely when in use The motor works intermittently The platform or hold down arm is not holding upright or EXPLODED VIEW - AL-010/050 EXPLODED VIEW - AL-030 EXPLODED VIEW - AL-100 EXPLODED VIEW - AL-300 EXPLODED VIEW - AL-301XL EXPLODED VIEW - AL-500 EXPLODED VIEW - AL-550 EXPLODED VIEW - AL-560