Manuals / Brands / Personal Care / Mobility Aid / Harmar Mobility / Personal Care / Mobility Aid

Harmar Mobility AL500 Drill as required, 4---1/4-20Nylock Nut, DO NOTUSE SPACERS HERE, 4---1/4-20x 1.00" HHCS, Find approximate center of the chair

1 36

Download 36 pages, 10.87 Mb

CHAIR PREPARATION

AL550 only

CHOOSING A LOCATION and MOUNTING THE DOCKING DEVICE PLATE

WARNING: Do not attempt to use this automatic lock down device on any folding, or take apart chairs unless recommended by Harmar.

The closer the plate is positioned to the drive wheels, the easier the chair will be to engage the Locking Device

Drive wheel

Find approximate center of the chair

DOCKING

DEVICE

PLATE

DO NOT USE SPACERS HERE

SPACERS BELONG UNDER THE

STATION ON THE PLATFORM

Use existing holes where ever possible.

If too little or no holes exist, holes need to be drilled. Remove power chair's batteries, and use plate as a template.

Drill as required.Attach to chair using supplied hardware.4---1/4-20 x 1.00" HHCS4---1/4-20 Nylock Nut

ATTACHED TO PLATE

Contents

Page UNPACKING THE LIFT WIRING THE VEHICLE 2BEGIN ROUTING THE VEHICLE HARNESS AT THE BATTERY Side mount Top mount VEHICLE HITCH AL123 AL125 hitch class bumper distance Bumper distance INSTALLATION Attach Lift to Hitch Post or Swing Away For AL030 ONLY CHAIR PREPARATION CHOOSING A LOCATION and MOUNTING THE DOCKING DEVICE PLATE Find approximate center of the chair DO NOTUSE SPACERS HERE Use existing holes where ever possible Drill as required SETTING DOCKING DEVICE HEIGHT Measure distance of mounting surface to ground Determine LIFT PREPARATION SETTING HOLD DOWN FOOT HEIGHT LIFT SHOULD HOLD WHEELCHAIR FIRMLY WITH THE PLATFORM FULLY RAISED ( RAISED UNTIL MOTOR RATCHETING IS HEARD ) FOR ADJUSTMENT PURPOSES, ALL PLATFORM COMPONENTS ARE SHIPPED LOOSE AND MUST BE FIRMLY TIGHTENED ONCE ADJUSTED BE SURE TO TIGHTEN ALL FASTENERS Page OPERATION General Operating Instructions: AL500, AL550 AL100, AL300 AL301XL Courtesy Note: Special Note: The AL100 LOADING THE POWER CHAIR Page UNLOADING THE POWER CHAIR LOADING A SCOOTER LOADING A POWER CHAIR 1 Insert Key and switch to "ON" position 2 Once platform has been lowered at least an Press down on Toggle switch momentarily to the ground LOADING THE WHEELCHAIR LOADING A POWER CHAIR Page MAINTENANCE: The lift does not operate The motor does not lift the platform completely when in use The motor works intermittently The platform or hold down arm is not holding upright or EXPLODED VIEW - AL-010/050 EXPLODED VIEW - AL-030 EXPLODED VIEW - AL-100 EXPLODED VIEW - AL-300 EXPLODED VIEW - AL-301XL EXPLODED VIEW - AL-500 EXPLODED VIEW - AL-550 EXPLODED VIEW - AL-560