OPERATION
To unload the power chair, simply turn ON the power switch and push the UP/DOWN toggle switch to the down position. Hold the s witch down until the platform just touches and is level to the ground. Press the red release button on the Anchor Strap Base to release the tension and unhook the strap from the chair. Continuing to press the button, allow the strap to retract until the hook reaches the housing. Repeat this step on each corner until all four straps are released. Drive your power chair off the lift platform. When the power chair is clear of the platform, raise the platform by pushing up on the UP/DOWN switch.
To bring the lift in the empty, stowed position, hold the UP switch. The platform will start up in the horizontal position. During its travel upward, the platform will fold up into the stowed or vertical position. Hold the switch until the platform travel stops automatically.
Courtesy Note: You may wish to advise the end user to remove the key from the power switch to avoid any tampering with the lift.
The lift features 1 of 2 Manual overrides ( both in the same location ) If the vehicle or lift loses power, simply remove the caution sticker
from the top of the motor box. TURN KEY OFF, and REMOVE 2 PRONG WIRING FROM THE LIFT TO AVIOD INJURY SHOULD
POWER SUDDENLY BE RESTORED. Some lifts require a 3/8" socket, others require a 1/2" socket. Turn the wrench clockwise to raise the lift and couter clockwise to lower.
(If the lift does not operate properly, immediately take it to the local dealer. DO NOT attempt to modify the lift in any way!)
Do not attempt to move the vehicle without the lift in the stowed or travel position. Any attempt to move the vehicle without the lift fully up may cause damage to the lift, power chair, scooter or vehicle.
The AL100 is shipped with the Spreader Bar Assembly already attached to the back of the platform on the lift. You must rotate it down until the hole in the side bracket lines up with the open hole on the attachment point on the platform. The Spreader Bar should be flat on the ground at this point. Tighten the bolts where the Spreader Bar Assembly attaches to the platform.
Load the scooter on the center of the platform. Adjust the spreader bar according to the size of the scooter that is being transported on the lift. Forward for smaller scooters and back for larger scooters. Make sure that all fasteners on the Spreader Bar Assembly are t ightened before attempting to use the lift.
With the toggle switch, raise the platform with the scooter on it. You will notice that as the lift reached the top, the hold down arm with the foot will lower to the deck of the scooter. The foot should put pressure down on the deck of the scooter to secure it in place while traveling. If the foot does not reach the scooter, unthread the adjustable leg until the foot rests securely on the deck of the scooter.
Thread the Adjustable Hold Down Foot onto the hold down arm. To begin, thread the rod completely into the arm. Lower the platform to the ground and place the scooter to be used on the lift and using the toggle switch, raise the platform and scooter up until it reaches the traveling position (all the way up). The lifting motor has a clutch mechanism that will stop the lift when it reaches the top. You will hear a clicking sound when the lift is at the top. Release the switch at this time.
16