Manuals / Brands / Personal Care / Mobility Aid / Harmar Mobility / Personal Care / Mobility Aid

Harmar Mobility AL500 LOADING THE WHEELCHAIR, to the ground. Raise hold down arm, Press down on Toggle switch momentarily, 1 Insert Key and switch to "ON" position

1 36

Download 36 pages, 10.87 Mb

OPERATION

AL030

LOADING THE WHEELCHAIR

"PLATFORM KEEPER"

DOWN

WELDED

PLATFORMTO

NOTE: The Platform will not be allowed to unfold until the platform has been lowered at least an inch.

1 Insert Key and switch to "ON" position	2 Once platform has been lowered at least an
Press down on Toggle switch momentarily.	inch, unfold the platform. Continue lowering
	to the ground. Raise hold down arm.

3 Roll folded chair onto platform as shown.	4 Raise the lift until hold down arm has
	contacted wheelchair's arm rests.

To remove the chair and prepare the lift for unloaded travel, follow above steps in reverse order and reverse the direction of the arrows.

Lift should be raised with the platform folded and until the lift's motor ratchets. Verify that the platform keeper has engaged the platform's pin.

RM	KEEPER
PLATFO

PLATFORM's PIN

Contents

Page UNPACKING THE LIFT WIRING THE VEHICLE 2BEGIN ROUTING THE VEHICLE HARNESS AT THE BATTERY Side mount Top mount VEHICLE HITCH AL123 AL125 hitch class bumper distance Bumper distance INSTALLATION Attach Lift to Hitch Post or Swing Away For AL030 ONLY CHAIR PREPARATION CHOOSING A LOCATION and MOUNTING THE DOCKING DEVICE PLATE Find approximate center of the chair DO NOTUSE SPACERS HERE Use existing holes where ever possible Drill as required SETTING DOCKING DEVICE HEIGHT Measure distance of mounting surface to ground Determine LIFT PREPARATION SETTING HOLD DOWN FOOT HEIGHT LIFT SHOULD HOLD WHEELCHAIR FIRMLY WITH THE PLATFORM FULLY RAISED ( RAISED UNTIL MOTOR RATCHETING IS HEARD ) FOR ADJUSTMENT PURPOSES, ALL PLATFORM COMPONENTS ARE SHIPPED LOOSE AND MUST BE FIRMLY TIGHTENED ONCE ADJUSTED BE SURE TO TIGHTEN ALL FASTENERS Page OPERATION General Operating Instructions: AL500, AL550 AL100, AL300 AL301XL Courtesy Note: Special Note: The AL100 LOADING THE POWER CHAIR Page UNLOADING THE POWER CHAIR LOADING A SCOOTER LOADING A POWER CHAIR 1 Insert Key and switch to "ON" position 2 Once platform has been lowered at least an Press down on Toggle switch momentarily to the ground LOADING THE WHEELCHAIR LOADING A POWER CHAIR Page MAINTENANCE: The lift does not operate The motor does not lift the platform completely when in use The motor works intermittently The platform or hold down arm is not holding upright or EXPLODED VIEW - AL-010/050 EXPLODED VIEW - AL-030 EXPLODED VIEW - AL-100 EXPLODED VIEW - AL-300 EXPLODED VIEW - AL-301XL EXPLODED VIEW - AL-500 EXPLODED VIEW - AL-550 EXPLODED VIEW - AL-560

LOADING THE WHEELCHAIR

to the ground. Raise hold down arm.

3 Roll folded chair onto platform as shown.

4 Raise the lift until hold down arm has