Hasselblad 848 manual Turn on the scanner by pressing its on/off switch

11

10.Grasp the Batch Feeder firmly with one hand while holding the batch-scan door open on the scanner with your other hand. Align the connector and pins on the back of the Feeder with the holes and con- nector inside the scanner. Gently press the Feeder down and in place, making sure that the Feeder sits firmly and has a good connection with the connector.

11.Turn on the scanner by pressing its on/off switch.

12.FlexColor detects that the scanner has been turned back on. The Mount feeder window updates with new instructions.

Click on Done to close the Mount feeder window.

13.If you have never used the Batch Feeder before, try to load it with a full set of 10 original holders and scan them all. If the Feeder works smoothly, then you are ready to begin work. However, if the scanner has trouble moving the original holders in and out, then you may need to align the Feeder to match your individual scanner. In this case, please see “Aligning the Feeder” on page 23.