Hasselblad 848 manual Mounting and Unmounting the Batch Feeder, Mounting the Batch Feeder



Mounting and Unmounting the Batch Feeder

The procedures for both mounting and unmounting the Feeder to/from your scanner require that you use the software-guided procedure, which ensures that the mechanical pars of the scanner and Feeder are correctly aligned for each step. Always use this software feature when you need to mount or unmount the Feeder. Otherwise, you may damage your Feeder and/or scanner. Also, the unmount procedure makes sure that the Feeder is correctly positioned for storage in its original box.

Mounting the Batch Feeder

Always use the software-guided procedure below to mount the Feeder. It is otherwise possible to damage the Feeder and/or scanner while mount- ing the Feeder

1.If you have not already done so, set up your Flextight Scanner, con- nect it to your computer and install the FlexColor software as de- scribed in your scanner and software user manuals. Confirm that the scanner is working correctly by making a test scan using one of the standard original holders.

2.If there is still an original holder mounted inside the scanner, then remove it. Close the light table, if it is open, by lifting its front edge. See your scanner manual for instructions.

3.Make sure the scanner is turned on and launch the FlexColor soft- ware. If FlexColor is already running, then quit and restart the pro- gram.

4.Select Maintenance > Feeder from the FlexColor menu bar.