Unlocking/locking the Feeder position | Hasselblad 848 instruction

NOTE! Do not touch similar looking nuts to the left.

26

2.Find the adjustment tool that was supplied with your Batch Feeder. It is a thin metal bar with notches cut at each end.

3.Use the adjustment tool to loosen the self-locking nut on the right side on the rear of the Feeder as indicated in Figure 8.

NOTE! Do not touch similar looking nuts to the left.

Figure 8: Unlocking/locking the Feeder position

4.Use the software-assisted procedure to mount the Feeder to the scan- ner as described in “Mounting the Feeder” on page 8. However when you get to the last step, keep the Mount feeder window open (do not click on Done)

Image 26

Hasselblad 848 manual NOTE! Do not touch similar looking nuts to the left, Unlocking/locking the Feeder position

Contents

Batch Feeder for Flextight 848 and 949 Scanners by HasselbladUser’s Guide Page Table of Contents General IntroductionImportant Warnings and Restrictions For All Users System RequirementsWhen Operating the Feeder For Macintosh Users B F G H Batch Feeder DiagramA C D E Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panel Mounting and Unmounting the Batch Feeder Mounting the Batch Feeder 5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder window Unmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the Feeder Figure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angle NOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder position You have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position 10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder window Shipping the Feeder Preparing the Feeder for Storage or ShippingStoring the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance Disposal Specifications Technical Information CE Declaration