Hasselblad 848 manual Adjusting the Loading Position, Bolts for adjusting the feeder angle

25

Figure 7: Bolts for adjusting the feeder angle

7.Use your fingers to turn the two adjustment bolts until that they look as though they will hold the bottom of the Feeder at the correct angle.

8.Use the software-assisted procedure to remount the Feeder to the scanner as described in “Mounting the Feeder” on page 8.

9.Check to see if the angle now looks correct. If not, then repeat this procedure until the angle is correct (always use the software-assisted procedure when mounting or unmounting the Feeder).

10.When the angle is set correctly, use the supplied adjustment tool to tighten the two nuts on the back of the adjustment bolts.

Adjusting the Loading Position

The Feeder must be positioned so that it inserts its original holders di- rectly into the clasp mounted on the drum inside the scanner. Use the procedure below only if your original holders are not being drawn in and out of the scanner smoothly during normal operation.

1.If the feeder is currently mounted, then use the software-assisted procedure to unmount the Feeder as described in “Unmounting the Feeder” on page 12.