Hasselblad 848 specification

You have already loosened the nut, so just click on Continue.

27

5.Click on the Align Feeder button. The Align Feeder window opens, which will now guide you through the procedure of aligning the feeder.

You have already loosened the nut, so just click on Continue.

6.The scanner moves into its adjustment (home) position and the Align Feeder window updates with new instructions.

Place the adjustment tool in the slit between the first and second mag- azine position on the Feeder as shown in Figure 9. Position the notch at the end of the tool over the adjustment pin inside the Feeder.

Image 27

Hasselblad 848 manual You have already loosened the nut, so just click on Continue

Contents

by Hasselblad User’s GuideBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Introduction Important Warnings and RestrictionsGeneral For Macintosh Users System RequirementsWhen Operating the Feeder For All Users Batch Feeder Diagram A C D EB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after Shipping Mounting the Batch Feeder Mounting and Unmounting the Batch Feeder Click on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switch Unmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder Angle Figure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading Position Figure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the left You have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool 10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder window Preparing the Feeder for Storage or Shipping Storing the FeederShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive Maintenance Technical Information Specifications CE Declaration