Preparing the Feeder for First Use or after Shipping
Before you begin to use the Feeder, you must remove the two shipping screws that secure the magazine during shipping. They are located near the bottom of the Feeder on the back side, as shown in Figure 2, below. On new Feeders, these are clearly marked by a label, which reminds you to remove them before use.
Figure 2: Location of the shipping screws on the Feeder back panel
Be sure to keep both the original packaging and the two shipping screws in a safe place. You should always store the Feeder in its original packag- ing while you are not using it. You must also replace the shipping screws and use the original packaging if you need to ship the Feeder (for exam- ple, to a new studio or back to Hasselblad for service).
See also “Preparing the Feeder for Storage or Shipping” on page 31 for more information about how to ship the Batch Feeder.
