Hawking Technology 108G manual Add PC

want remove all PCs from the table, just click "Delete All" button.

Filter client PC by MAC address Check “Enable MAC Filtering” to enable MAC

	Filtering.
Add PC	Fill in “Client PC MAC Address” and “Comment”
	of the PC that is allowed to access the Internet, and
	then click “Add”. If you find any typo before
	adding it and want to retype again, just click
	"Reset" and the fields will be cleared.
Remove PC	If you want to remove some PC from the "MAC
	Filtering Table", select the PC you want to remove
	in the table and then click "Delete Selected". If you
	want remove all PCs from the table, just click
	"Delete All" button. If you want to clear the
	selection and re-select again, just click “Reset”.

You can now configure other advance sections or start using the router (with the advance settings in place)

Add PC

Parameters	Description
Client PC Description	The description for this client PC rule.
Client PC IP Addresses	Enter the IP address range that you wish to apply this
	Access Control rule. This is the user’s IP address(es)
	that you wish to setup an Access Control rule.
	Note: You need to give your LAN PC clients a
	fixed/static IP address for the Access Control rule to
	work properly.
Client PC Service	You can block the clients from accessing some
	Internet services by checking the services you want
	to block.
Protocol	This allows you to select UDP, TCP or both
	protocol type you want to block.
Port Range	It can be assign up to five port ranges. The router
	will block clients from accessing Internet services
	that use these ports.
	75