DIVA T/A PC Card User’s Guide 11
Windows 95
Note: This install procedure is for the original release and Service
Pack 1 (SP1) version of Windows 95. If you are using Windows 95
Service Release 2 (OSR2), go to page 13.
To verify the version installed on your machine, go to Control
Panel/System Properties and select the General tab. If you have the
original or SP1 version of Windows 95, it should show as one of the
two screens below:
Note: If you are using Dial-Up Networking, make sure you are using
version 1.2. If you are running a previous version, you must upgrade
to Dial-Up Networking 1.2, before you begin installing the DIVA T/A.
Dial-Up Networking 1.2 is located on the DIVA T/A CD under the
\MSDUN12 directory. Refer to your Windows 95 online help for
information on how to install Dial-Up Networking.
1
After connecting the cables (see the section “Connecting the
Cables” on page 8), turn on your PC. Insert the DIVA T/A, label
side up, into the PC Card Slot. The DIVA T/A is automatically
detected and the New Hardware Found Window appears.
2
Insert the DIVA T/A CD into your computer’s CD drive.
3
In the New Hardware Found Screen, select Driver from disk
provided by hardware manufacturer, and click OK; the Install
From Disk window appears.