1.12 | ASSEMBLY INSTRUCTIONS | 1.12 |
|
|
|
ASSEMBLING THE MOWER FOR THE FIRST TIME
Check that parts are delivered correctly: Remove the mower from the packaging and check that all loose items have been supplied correctly. Refer to the delivery check- list opposite and the general assembly. If any items are missing contact, your local Hayter dealer.
Assemble the handlebar: Unscrew the handlebar securing knobs sufficiently to allow the handlebar to be pivoted. Move the engine stop lever away from the engine to avoid damage and unfold the handlebar to its operating position. Ensure that both Knobs are on the outside of the handlebar and the cable guide is positioned as shown. Tighten to secure handlebar in position.
IMPORTANT - PREVENT DAMAGE : When unfold- ing the handlebar, take care to ensure that the controls and cables do not become damaged. Always replace damaged controls and cables before using the mower.
DELIVERY CHECKLIST
DescriptionQuantity
Grassbag | 1 |
Owner’s Handbook | 1 |
Warranty Registration Card | 1 |
|
|
CS005
CS072
Adjust height of handlebar: Unscrew the two larger Knobs at base of handlebar sufficiently to allow it to be moved to the upper, middle or lower position. Secure in best position for comfort. Ensure that both sides are set to the same height.
Assemble the grassbag: Remove the long ribbon label by cutting it off close to the grassbag. Discard the ribbon label.
WARNING - AVOID ENTANGLEMENT : Completely |
remove this ribbon before using the mower |
Grassbag attachment: Raise the rear deflector. Lower the grassbag through the handlebar and hook in position behind the deflector springs. Lower the grassbag to rest against the rear of the mower. Finally, lower the rear deflector to rest against the top of the grassbag.
CS006
CS009
CS007
485101MT210999A
