Hayter Mowers RZT420H manual Adjusting the Height of Cut, Adjusting the Motion Control Levers

blade control switch, ensure the throttle is in the fast position, and turn the ignition key to off. Remember to remove the key from the ignition switch.

Children or bystanders may be injured if they move or attempt to operate the machine while it is unattended.

Always remove the ignition key and move the motion control levers outward to the park position when leaving the machine unattended, even if just for a few minutes.

Adjusting the Height of Cut

1.Raise the height-of-cut lever to the transport position, cutting height position G (also the 4-1/2 inch [115 mm]) (Figure 21).

Figure 22

1.Adjustment knob

2.Move the seat to the desired position and tighten the knob.

Adjusting the Motion Control Levers

Adjusting the Height

The motion control levers can be adjusted higher or lower for maximum operator comfort.

1.Remove the 2 bolts holding the control lever to the control arm shaft (Figure 23).

2.Move the control lever to the next set of holes. Secure the lever with the 2 bolts (Figure 23).

Figure 21

1. Height-of-cut lever 2. Height-of-cut positions

2.To adjust the height of cut, pull inward and up on the lever and move it to the desired position.

Positioning the Seat

The seat can move forward and backward. Position the seat where you have the best control of the machine and are most comfortable.

1.Raise the seat and loosen the adjustment knob just enough that seat can move (Figure 22).

Figure 23

1.	Control arm shaft	3.	Slotted, upper hole
2.	Control lever	4.	Bolt

3.Repeat the adjustment for the opposite control lever.

21