Wayne-Dalton 46 Attaching Fully Adjustable, Flagangle to Vertical Track, Bottom Bracket

2	Attaching Fully Adjustable		Fully Adjustable
	Flagangle to Vertical Track		flagangle
Tools Needed:	NOTE: If you have riveted track, skip this
None	step.
	Hand tighten the flagangle to the
	vertical track using (2) 1/4”- 20 x 5/8”
	carriage bolts and (2) 1/4”- 20 flange
	hex nuts.
	Repeat for opposite side.
	The flange nuts will be tightened after
	flagangle spacing is complete (Step 14).
		(2) 1/4”- 20
		flange hex			(2) 1/4”- 20 x 5/8”
		nuts
					carriage bolts
				vertical	INSTALLATION
				track
3	Bottom Bracket			left hand
				Bottom Bracket
Tools Needed:	NOTE: For door section identification see
Power Drill	page 4.
7/16” Socket	Align the center hole of bottom bracket
Driver	with hole #3 in the end stile of bottom
Torx Bit	section. Fasten with (2) 1/4”-20 x 11/16”
	self drilling screws and (1) 1/4”-20 x 5/8”				(2) 1/4”-20 x 11/16”
	tamper-resistant self drilling screw as				self drilling
	shown.				screws
	Repeat for other side.		7	#3 hole	(1) 1/4”- 20 x 5/8”
					tamper-resistant
	NOTE: All doors are provided with the				self drilling
				Bottom	screw
	tamper resistant fastener for the bottom
				Bracket
	brackets. However, the professional
			6	center hole
	installer is most likely to have the
		5			warning
	proper tool to install this fastener. If the		4
	homeowner does not have the proper tool				label
		3
	to install the tamper resistant fastener,		2
	use a regular 1/4 – 20 x 7/8” self drilling
			1
	screw in its place.
		end stile hole		Bottom	Bottom
		pattern
					section
		(Left side is shown.		Bracket
		right side is
		opposite.)
					9

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com