Wayne-Dalton 46 installation instructions TorqueMaster Spring Tube, Center Bracket Bushing

17	TorqueMaster® Spring Tube
Tools Needed:	TorqueMaster® springs come lubricated
None	and pre-assembled inside the
	TorqueMaster® spring tube. To install, lay
	the TorqueMaster® spring tube on the
	floor (inside garage) in front of the door
	with the labeled end to the left.
	IMPORTANT: Right and left hand is
	always determined from inside the
	garage looking out.

TorqueMaster®

Spring Tube

LABELED END

18	Center Bracket Bushing
		CENTER
Tools Needed:	NOTE: If you are installing the idrive®	BRACKET
		ASSEMBLY
None	opener with your garage door, skip this
	step and go to your idrive® Installation
	Instructions and Owner’s Manual. After
	completing steps 1-13 of your idrive®	TorqueMaster®
	Installation Instructions and Owner’s	Spring Tube
	Manual, rear supports will need to be
	fabricated/installed to support both
	horizontal tracks, see step 27.
	NOTE: If you are not installing the
	idrive® opener on your garage door, you	TorqueMaster®
	must install the center bracket bushing
	assembly. Follow these instructions for	Spring Tube
	non-idrive®operated garage doors.

Being cam shaped, the center bracket bushing only fits one way.

Slide the center bracket assembly towards the center of the TorqueMaster® spring tube, from the right side as shown.

CENTER

BRACKET

BUSHING

18

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com