Wayne-Dalton 46 installation instructions Hinges

5		3
	Hinges	1
		2
Tools Needed:	Position the lower (numbered) leaf of the	4
Power Drill	#1 end hinge over the #1 and #4 holes in	5
	the top of the end stiles, and secure to the	6
7/16” Socket	end stiles by 1/4”-14 x 5/8” self tapping
	screws. Position and secure #1 center
Driver
	hinge(s) with 1/4”-14 x 5/8” self tapping
					roller
	screws using the pre-punched holes in	7			placement
	the top of the center stile(s).
	NOTE: The #1 hinges serve as end hinges			#1 Hinge	#2 End Hinge
	on the bottom section. The #1 hinges also
	serve as center hinges at all center hinge
	locations.
	Insert roller into appropriate hinge tubes.					INSTALLATION
	Repeat for all other sections using the #2
	end hinges on the second (lock section)
	and the #3 end hinges on the third section
	(intermediate section).
	NOTE: #4 End hinges are used on fourth				roller
					placement
	section of five section doors.	end stile hole		roller
		pattern	center stile	placement
	IMPORTANT: When placing rollers	(Left side is shown.
			hole pattern
	into end hinges #2 and higher, the	right side is		#3 End Hinge	#4 End Hinge
		opposite.)
	roller goes into the tube furthest
	away from section.
	IMPORTANT: once fastener are
	snug against hinge leaf, tighten an
	additional 1/4 to 1/2 turn to receive	#1 hole		hinge
	maximum design holding power.
		#4 hole
		end stile		(2) 1/4”-14 x 5/8”
					self tapping
					screws
			end hinge placement
				hinge
			center stile		(2) 1/4”-14 x 5/8”
					self tapping
					screws
			center hinge placement
					11

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com