| Winding Springs Continued... | End Bracket |
|
|
|
|
|
| |
Tools Needed: | onto the left hand winding shaft end. To |
|
|
|
wind the spring, rotate the winding shaft |
|
|
| |
|
|
|
| |
| clockwise, while watching the mark on the |
|
|
|
| winding shaft. |
|
|
|
| Rotate the winding shaft to the required |
|
|
|
| number of turns for your door. Then return |
|
|
|
| to the right hand side and wind the right |
|
|
|
| hand spring to the required number of |
|
|
|
| turns. Place pawl knob in lower position on |
|
|
|
| both sides. |
|
|
|
| IMPORTANT: Mark Number of Spring |
|
|
|
| Turns on TorqueMaster® Plus end |
|
|
|
| bracket warning tag. |
|
|
|
| NOTE: Since total turns to balance door | Pawl Knob in Lower |
| |
| can deviate from spring turn chart |
| Position |
|
| values by ± 1/2 turn, adjustments to the | Back of torquemaster® | plus end bracket warning tag | |
| recommended number of turns may be | |||
| required after the rear hanger assembly |
|
|
|
| is completed. |
|
|
|
| IMPORTANT: Hold the door down to |
|
|
|
| prevent it from raising | Spring Turns |
| |
| unexpectedly, in the event the |
| ||
| Door Height Spring Turns |
| ||
| spring was overwound and | (6’ - 0”) | 14 |
|
| cautiously remove vice clamps from | (6’ - 3”) | 14 - 1/2 |
|
| vertical tracks. | (6’ - 5”) | 15 |
|
| (6’ - 6”) | 15 |
| |
| Do not raise the door until horizontal |
| ||
| (6’ - 8”) | 15 - 1/2 |
| |
| tracks are secured at the rear, as outlined |
| ||
| (6’ - 9”) | 15 - 1/2 |
| |
| in step 27. | (7’ - 0”) | 16 | Location for |
| WARNING | (7’ - 3”) | 16 - 1/2 | |
| (7’ - 9”) | 17 - 1/2 | of installed | |
|
| (7’ - 6”) | 17 | marking number |
| Raising door further can | (8’ - 0”) | 18 | spring turns |
|
|
| ||
| result in door falling and | Number of Installed Spring Turns |
| |
26 | cause severe or fatal injury. |
|
|
|
Drum Wrap Installation | drum |
|
| |
|
|
|
| |
| Starting with the left hand side, align | (left hand) |
|
|
|
|
|
| |
None | the counterbalance cable with one of |
|
|
|
the slots in the drum wrap. Slide the |
|
|
| |
| drum wrap over the drum until the tabs |
|
|
|
| snap between the cable drum and the |
|
|
|
| ratchet gear. Repeat for right hand side. |
|
|
|
|
| Counterbalance cable |
| |
|
|
| tabs |
|
|
| groove |
|
|
|
| in drum |
|
|
26 |
|
|
|
|
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at