Wayne-Dalton 46 installation instructions Lift Handle, Bottom Section, Vertically aligned

9	Lift Handle
Tools Needed:	NOTE: Doors with a Keyed lock do not require this lift
	handle.
Tape Measure
Pencil	NOTE: For door section identification see page 4.
Power Drill	Locate the inside center stile or the desired lift handle
	location on the lock (2nd) section of the door. Position
9/32” Drill Bit	the lower hole in the lift handle 4” from the bottom of
	the second section.
1/2” Drill Bit	IMPORTANT: The lift handle and the step/lift plate
1/4” Wrench	need to be vertically aligned.
	Drill (2) 9/32” dia. holes through section. Enlarge the
	holes from outside the door to 1/2” dia.
	Assemble the outside and inside lift handle to the
	section using (2) 1/4” x 2-1/2” carriage bolts,
	( 2) 1/4”- 20 hex nuts and (2) spacers.
	NOTE: Do not drill through or enlarge holes on the
	inside of the door.

Lock

Section

Lift

handle

(2) spacers

(2) 1/4” x 2-1/2” bottom Carriage bolts Section

lift handle outside

Lock

Section

Lift	(2) 1/4”-20
handle
	Hex Nut

bottom Section

lift handle inside

Lock

Section

Lift

handle

4”

MAX.

Vertically aligned

bottom Section

8” MAX.

10	Bottom Section
Tools Needed:	Center the bottom section in the door
Level	opening. Level section using wooden	jamb
	shims (if necessary) under the bottom
		header
	section.

weather

seal

level

jamb

Wooden Shims (if necessary)

bottom section

14

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com