Wayne-Dalton 46 installation instructions Cable Adjustment

24	Cable Adjustment
Tools Needed:	Starting on the right hand side, rotate
Pliers	the cable drum until the set screw
	faces directly away from the header.
Flat Tip	Torque tube cam peak should be

1/2 wrap Shown

Cam peak

First groove

Screwdriver pointing straight up. Loosen the set

Set screw Right hand drum

	screw no more than 1/2 turn. Using
Step Ladder	locking pliers, pull on the end of the
	cable to remove all cable slack.
	IMPORTANT: a MINIMUM of a 1/2
	wrap IS REQUIRED FOR PROPER DOOR
	OPERATION. Cable must be taut and
	in the first groove of the cable
	drum.

1-1/2 wrap Shown

Cam peak

First groove

Check to ensure the cable is aligned

and seated in the first groove of the

cable drum. Snug the set screw, and

then tighten an additional 1-1/2 turns.

Left side will be adjusted in Step 23.

IMPORTANT: ENSURE THE CABLE IS

ALIGNED AND SEATED IN THE FIRST

GROOVE OF THE CABLE DRUM PRIOR

TO WINDING SPRINGS.

Leave approximately 6” of cable and cut

off the rest. Insert excess cable into hole

of cable drum.

NOTE: Illustrations show the right hand

TorqueMaster® Plus drum, left hand

TorqueMaster® Plus drum is

symmetrically opposite.

Set screw Right hand drum

Cable drum hole

Cut cable here

6”

Pliers

24

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com