Wayne-Dalton 46 installation instructions Cable Drums

Models: 46

1 36
Download 36 pages 28.31 Kb
Page 20
Image 20
Cable Drums

20

Cable Drums

 

Tools Needed:

IMPORTANT: RIGHT AND LEFT HAND

Tape Measure

IS ALWAYS DETERMINED FROM INSIDE

THE GARAGE LOOKING OUT.

 

 

Shake the TorqueMaster® spring tube

 

assembly gently to extend the winding

 

shafts out about 5" on each side. For

 

single spring applications, there will be

 

no left hand spring in the

 

TorqueMaster® spring tube assembly.

 

Lift the TorqueMaster® spring tube

 

assembly and rest it on the top of the

 

flagangles.

 

NOTE: Cable drums are marked right

 

and left hand. Cable drums and

 

TorqueMaster® spring tube assembly

 

are cam shaped to fit together only one

 

way.

 

Pre-wrap the TorqueMaster® plus cable

 

drum with the counter balance cable

 

with 1/2 or 1-1/2 wraps (see

 

illustration)

 

To install the cable drum, slide the

 

correct cable drum over the winding

 

shaft until the cable drum seats against

 

the TorqueMaster® spring tube

 

assembly.

 

The winding shaft must extend past the

TorqueMaster®

Spring Tube Assembly

Winding

Shaft

5”

 

 

TorqueMaster® Spring Tube

Right Drum

Counterbalance Cable

Assembly

 

 

 

 

 

 

 

 

 

 

 

1/2 Wrap Shown

 

 

TorqueMaster® Spring Tube

 

 

 

Right Drum

Counterbalance Cable

 

Assembly

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1-1/2 Wrap Shown

Splines

Groove

Winding shaft

cable drum far enough to expose the

splines and the groove. Align the

winding shaft groove with the round

notch in the flagangle.

For double spring applications:

Repeat for opposite side.

For single spring applications: Insert

Round Notch Manual background Flagangle Manual background

Cable Drum

the loose winding shaft into the left

hand cable drum prior to sliding the

cable drum over the TorqueMaster®

spring tube assembly.

NOTE: On single spring applications,

take care in handling the loose winding

shaft (left side) so that it does not slide

back into the TorqueMaster® spring

tube assembly.

20

CounterbalanceManual background CableManual background

Winding shaft

Cable

Drum

Groove

Splines

Use th thislabeesel.Illustr

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 20
Image 20
Wayne-Dalton 46 installation instructions Cable Drums