Wayne-Dalton 46 installation instructions Tools Required, Removing an Existing Door

	Tools Required
power drill	pencil	ratchet Wrench	Pliers/wire cutters	7/16”, 1/2” socket	gloves	level
				driver
Phillips Head	1/2”, 9/16”, 5/8”	1/8”, 3/16”, 9/32”,	vice grips	1/4”, 3/8”, 7/16”, 1/2” &	Torx Bit	hammer
Screwdriver	& Socket	5/16”, 1/2” drill bits		9/16” Wrenches
		Hacksaw	Tape Measure	(2) vice clamps
(2) sawhorses		3” extension	Flat Tip Screwdriver	Safety Glasses		Step Ladder

Removing an Existing Door

Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.

WARNING

A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INJURY. TO AVOID INJURY HAVE A TRAINED DOOR SYSTEMS TECHNICIAN, USING PROPER TOOLS AND INSTRUCTIONS, RELEASE THE SPRING TENSION.

For detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt. Hope, OH 44660, or at www.wayne-dalton.com.

5

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com