Wayne-Dalton 46 TorqueMaster Plus Reset, Instructions Continued, Tools Needed

	TorqueMaster® Plus Reset
	Instructions Continued...
Tools Needed:	second roller on the other side. This
	will prevent the door from raising or		place vice clamps
	lowering while adjusting the spring(s).
			above 3rd Roller on
	To Add Spring Tension:		both vertical tracks
	The ratchet wheel is made of 10 teeth.
	To add spring tension, ensure the
	ratchet and socket is set so that it will		vice clamps	Track
	tighten counter clockwise on the right
			attached to
	hand side, and clockwise on the left		inner rail
	hand side. Place the ratchet with 5/8”		of track
	socket onto the winding shaft, pull down
	to add 3/10 of a turn. Watch as three
	teeth of the ratchet wheel pass over the
	ratchet pawl, creating three “clicks”.
	To Remove Spring Tension:			INSTALLATION
	hand side. It is recommended that a
	To remove spring tension, ensure the
	ratchet and socket is set so that it will	Lower Position	UPPER Position
	tighten counter clockwise on the right
	hand side and clockwise on the left
	regular 5/8” wrench be used. Place
	the wrench onto the winding shaft.
	Pull down on the wrench to relieve
	pressure between the ratchet pawl
	and the ratchet wheel. Push in on the
	pawl to allow the three ratchet wheel
	teeth to pass by the ratchet pawl, as
	you carefully allow the wrench to be
	rotated upward by the spring tension.
	Release the pawl to allow ratchet pawl
	to engage with the ratchet wheel.
	Remove the vice clamps from the
	vertical tracks, re-check doors balance	Pawl knob in Lower	Pawl knob in upper
	and adjust if necessary. When door is
		Position	Position
	balanced and adjusted properly, place
	the ratchet pawl knobs in the active
	position (lower position).
			End Bracket	Ratchet
				with 5/8”
				Socket
		PAWL
			3” Extension
				31

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com