Wayne-Dalton 46 installation instructions Top Section, Vertical Track Alignment

13	Top Section
Tools Needed:	Place the top section in the opening and
Hammer	vertically align with lower sections.
Nail	Temporarily secure the top section by
	driving a nail in the header near the
Power Drill	center of the door and bending it over
	the top section.
7/16” Socket	Now flip up the hinge leaf against
Driver	section, fastening center hinge(s) first
7/16” Wrench	and end hinges last.
Tape Measure

NAIL	door width
	+3-3/8” to 3-1/2”

14	Vertical Track Alignment
Tools Needed:	When installing a door with a
Power Drill	TorqueMaster® Plus counterbalance
	system, vertical track alignment is
7/16” Socket	critical. Position flagangle between
Driver	1-11/16” (43 mm) to 1-3/4” (44 mm)
Tape Measure	from the edge of the door. Tighten the
	bottom lag screw. Flagangles must be
	parallel to the door sections. Repeat for
	opposite side.
	IMPORTANT: THE DIMENSION BETWEEN
	THE FLAGANGLES MUST BE DOOR WIDTH
	PLUS 3-3/8” (86 MM) TO 3-1/2” (89 MM)
	FOR SMOOTH, SAFE DOOR OPERATION.
	Complete the vertical track installation	FLAGANGLE	1-11/16” TO 1-3/4”
	by securing the center jamb bracket(s)	vertical track
	and tightening the other lag screws. Push
		ROLLER
	the vertical track against the rollers so		top section
	that the rollers are touching the deepest
	part of the curved side of the track (see
	illustration). Tighten all the carriage bolts
	and nuts. Repeat for opposite side.	ROLLER Against
		VERTICAL TRACK

16

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com