Manuals / Wayne-Dalton / Household Appliance / Door

Wayne-Dalton 46 Securing Center Bracket Bushing, NOTE: If you are not installing the

Models: 46

1 36

Page 22


	22	Securing Center Bracket Bushing
	Tools Needed:	NOTE: If you are not installing the
	Power Drill	idrive® opener on your garage door, you
	Power Drill	must install the center bracket bushing
		must install the center bracket bushing
	3/16” Drill Bit	assembly, follow these instructions.
	3/16” Drill Bit
	7/16” Socket	To locate the center bracket, mark the
	Driver	header halfway between the flagangles
	Step Ladder	and level the TorqueMaster® spring
	Step Ladder	tube. Drill 3/16” pilot holes into header
		for the lag screws. Fasten the metal
		bracket to the header using
		(2) 5/16” x 2” lag screws.

CENTER

BRACKET

ASSEMBLY

(2) 5/16” x 2” hex head lag screws

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 22

Image 22

Wayne-Dalton 46 Securing Center Bracket Bushing, NOTE: If you are not installing the, assembly, follow these instructions

Contents

8000 Series, Model Installation Instructions and Owner’s ManualTorqueMaster Plus - Single and Double Spring Definition of key words used in this manual Table of ContentsPackage Contents Package Contents Continued Door Section IdentificationTools Required Removing an Existing Doorsecurely attach a Preparing the OpeningFailure to suitable mounting pad to structurallyINSTALLATION Cutting Vertical Track and Installing Fully Adjustable JambBrackets Flagangle to Vertical Track Attaching Fully AdjustableBottom Bracket Drums Hinges Top Bracket Step PlateU-Bar Bottom Section Lift HandleVertically aligned Stacking Sections Vertical TrackINSTALLATION Top Section Vertical Track AlignmentHorizontal Track Adjusting Top BracketsINSTALLATION TorqueMaster Spring Tube Center Bracket BushingDrum Wraps INSTALLATIONCable Drums securely attached to both End End BracketsINSTALLATION Bracketsbracket to the header using NOTE: If you are not installing theassembly, follow these instructions Securing Center Bracket BushingINSTALLATION Securing Doorfor Spring Winding Tools NeededCable Adjustment Winding Springs INSTALLATIONRaising door further can Drum Wrap InstallationWinding Springs Continued result in door falling andRear Support INSTALLATIONRear Support Continued Instructions TorqueMaster Plus ResetATTEMPTING TO RESET THE READ THESE INSTRUCTIONSInstructions Continued TorqueMaster Plus ResetInstructions Continued TorqueMaster Plus ResetTools Needed Side Lock FATAL INJURY optional INSTALLATIONPull Rope ROPE CAUSING SEVERE ORAND OWNER’S MANUAL, TO Trolley OperatorMONTHLY THEREAFTER AS DESCRIBED IN YOUR TO TEST OR MAKE ANYmaintenance CleaningPainting Thank you for your purchase Limited Warranty Models 8000, 8100, 8200 andPlease Do Not Return This Product To The Store

Securing Center Bracket Bushing

assembly, follow these instructions.

and level the TorqueMaster® spring

for the lag screws. Fasten the metal

bracket to the header using

(2) 5/16” x 2” lag screws.