Manuals / Wayne-Dalton / Household Appliance / Door

Wayne-Dalton 46 installation instructions Installation

Models: 46

1 36

Page 7

Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and the header level. Side clearance, from edge of door to wall, must be minimum of 3-1/2” (89 mm) on each side.

IMPORTANT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS MUST BE USED WHEN INSTALLING CENTER BEARING BRACKETS, END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS ON TREATED LUMBER (PRESERVATIVE-TREATED). STAINLESS STEEL LAG SCREWS ARE NOT NECESSARY WHEN INSTALLING PRODUCTS ON UNTREATED LUMBER.

NOTE: It is recommended that 5/16” x 2” lag screws will be pilot drilled using a 3/16” drill bit, prior to fastening.

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 7

Image 7

Wayne-Dalton 46 installation instructions Installation

Contents

8000 Series, Model Installation Instructions and Owner’s ManualTorqueMaster Plus - Single and Double Spring Table of Contents Definition of key words used in this manualPackage Contents Door Section Identification Package Contents ContinuedRemoving an Existing Door Tools Requiredsuitable mounting pad to structurally Preparing the OpeningFailure to securely attach aINSTALLATION Cutting Vertical Track and Installing Fully Adjustable JambBrackets Flagangle to Vertical Track Attaching Fully AdjustableBottom Bracket Drums Hinges Step Plate Top BracketU-Bar Bottom Section Lift HandleVertically aligned Stacking Sections Vertical TrackINSTALLATION Vertical Track Alignment Top SectionHorizontal Track Adjusting Top BracketsINSTALLATION Center Bracket Bushing TorqueMaster Spring TubeINSTALLATION Drum WrapsCable Drums Brackets End BracketsINSTALLATION securely attached to both EndSecuring Center Bracket Bushing NOTE: If you are not installing theassembly, follow these instructions bracket to the header usingTools Needed Securing Doorfor Spring Winding INSTALLATIONCable Adjustment INSTALLATION Winding Springsresult in door falling and Drum Wrap InstallationWinding Springs Continued Raising door further canINSTALLATION Rear SupportRear Support Continued READ THESE INSTRUCTIONS TorqueMaster Plus ResetATTEMPTING TO RESET THE InstructionsTorqueMaster Plus Reset Instructions ContinuedInstructions Continued TorqueMaster Plus ResetTools Needed Side Lock ROPE CAUSING SEVERE OR optional INSTALLATIONPull Rope FATAL INJURYTO TEST OR MAKE ANY Trolley OperatorMONTHLY THEREAFTER AS DESCRIBED IN YOUR AND OWNER’S MANUAL, TOmaintenance CleaningPainting Thank you for your purchase Limited Warranty Models 8000, 8100, 8200 andPlease Do Not Return This Product To The Store