� | Step Plate | |
| ||
Tools Needed: | NOTE: For alternative step/lift plate | |
| installation, see “Step Plate” in the | |
Pencil | optional installations on page 33. | |
| ||
1/4” Wrench | Locate the center stile on the bottom | |
5/16” Drill Bit | section of the door. | |
| ||
Power Drill | On the outside of the door, position step | |
plate directly above astragal retainer. | ||
| ||
| Using the step plate as a template, | |
| mark hole locations for mounting on |
bottom section
step plate
bottom
section
step plate assembly
(2)
Inside step plate installation
door face. |
Drill (2) 5/16” dia. holes through the |
door face and insulation, if necessary, at |
marked locations, being careful to keep |
drill straight. |
Mount step plates back to back, |
straddling stile. Secure with |
(2)1/4 x
bottom section
step plate
(2)1/4 x
bottom section
step plate assembly
outside step plate installation
� | Pull Rope |
| |
Tools Needed: | WARNING |
| |
Power Drill | DO NOT INSTALL PULL ROPES |
1/8” Drill Bit | ON DOORS WITH ELECTRIC |
OPERATORS. CHILDREN MAY | |
| BECOME ENTANGLED IN THE |
| ROPE CAUSING SEVERE OR |
| FATAL INJURY. |
| Measure and mark the jamb |
| approximately 48” to 50” (1220 to 1270 |
mm)from floor on the right or left side of door. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.
NO. 6 SCREW EYE
PULL ROPE
PULL ROPE
BOTTOM
BRACKET
optional INSTALLATION
33
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at