HOW TO TURN ON THE POWER
BPlug in the power cord (see page 8).
Bocate the reset/off circuit breaker on the
treadmill | near the power | Reset | |
Position | |||
cord. Move the circuit | |||
| |||
breaker | to the reset |
| |
position. |
|
| |
_1 Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 9)
and slide the clip onto the waistband of your clothes. Next, route the cord attached to the clip under the handgrip pulse sensor, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
BInsert the key into the console.
See HOW TO TURN ON THE POWER above.
B Select the manual mode.
When the key is in- | It | |
serted, the manual | ||
| ||
mode will be selected |
| |
and the indicator on the | OneTouch PROG_ | |
| ||
Manual Control button |
|
will light. If you have se-
lected a program, reselect the manual mode by pressing the Manual Control button.
D Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the twelve Quick Start buttons.
If the Start button or the Speed increase button is pressed, the walking belt
will begin to move at 1SPEED mph. As you exercise,
change the speed of the
walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph.
If one of the Quick Start buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting. Note: The
console can display speed and distance in ei- ther miles or kilometres. For simplicity, all in- structions in this section refer to miles.
To stop the walking belt, press the Stop button. The time will begin to flash in the Pace/Time dis- play. To restart the walking belt, press the Start button, the Speed increase button, or one of the twelve Quick Start buttons.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 27).
B Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the Incline increase and de-
crease buttons. Each time _:= D#STANCE _ INCLINE a button is pressed, the
incline will change by 0.5%.
_ ollow your progress with the matrix and the displays.
The
manual mode or the iFIT.com mode is se- lected, the matrix will display a
As you exercise, the in- dicators around the track
will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.
10
