9 Appliance Preparation
A. Choosing the Top or Rear Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting, it CANNOT be changed at a later time.
Figure 9.1 For top vent, remove the two screws holding the elbow heat shield in place. Use this heat shield over the first elbow if applicable. For rear vent skip this step.
Figure 9.4 Remove the seal cap.
NOTICE: Once the seal cap has been removed it CANNOT be reattached.
Figure 9.2 Cut the seal cap strap across the rectangles next to the disk.
Figure 9.5 Remove the insulation basket and white insu- lation from the center vent pipe.
Proceed to Section 7. C.
Figure 9.3 Remove the white gasket material covering the seal cap.
36 | Heat & Glo • |
