6.Place the (4) 3/8" lag screws through the air compressor feet, washers, shims, and into the anchors.
7.Torque 3/8" lag screws to
Wiring Instructions
Improper electrical instal- lation of this product may void its war- ranty and your fire insurance. Have circuit wiring performed by qualified personnel such as a licensed electrician who is familiar with the current national electrical code and any prevailing local electrical codes.
3/8" Lag
Screw
(not supplied)
Surface Line
Concrete Anchor
(not supplied)
Risk of electrical shock. Improper electrical grounding can result in electrical shock. The wiring should be done by a qualified electrician
A qualified electrician needs to knows the following before wiring:
1.The amperage rating of the electrical box should be adequate. Refer to the Specification Chart, in the parts manual, for this information.
2.The supply line should have the same electrical characteristics (voltage, cycle, phase) as the motor. Refer to the motor nameplate, on side of motor, for this information.
NOTE: The wiring must be the same as the motor nameplate voltage plus or minus 10%. Refer to local codes for recommended wire sizes, correct wire size, and maximum wire run; undersize wire causes high amp draw and overheating to the motor.
Risk of electrical shock. Electrical wiring must be located away from hot surfaces such as manifold assembly, compressor outlet tubes, heads, or cylinders.
GROUNDING INSTRUCTIONS
This product should be connected to a metallic, permanent wiring system, of an
Voltage and Circuit Protection
Refer to the specification chart for the voltage and minimum branch circuit require- ments.
Certain air compressors can be operated on a 15 amp circuit if the following conditions are met.
1.Voltage supply to circuit must comply with the National Electrical Code.
2.Circuit is not used to supply any other electrical needs.
3.Extension cords comply with specifications.
4.Circuit is equipped with a 15 amp circuit breaker or 15 amp time delay fuse. NOTE: If compressor is connected to a circuit protected by fuses, use only time delay fuses. Time delay fuses should be marked "D" in Canada and "T" in the US.
If any of the above conditions cannot be met, or if operation of the compressor repeatedly causes interruption of the power, it may be necessary to operate it from a 20 amp circuit. It is not necessary to change the cord set.
Air Distribution System
Plastic or PVC pipe is not designed for use with compressed air. Regardless of its indicated pressure rating, plastic pipe can burst from air pressure. Use only metal pipe for air distribution lines.
9 - ENG | N020206 |
