Porter-Cable C7501M, N020206-NOV08-0 To Drain Tank, Oil, Checking, Sight glass C, Changing

To Drain Tank

Risk of unsafe operation. Air tanks contain high pressure air. Keep face and other body parts away from outlet of drain. Use eye protection [ANSI Z87.1 (CAN/CSA Z94.3)] when draining as debris can be kicked up into face.

Risk from noise. Use ear protection (ANSI S12.6 (S3.19) as air flow noise is loud when draining.

NOTE: All compressed air systems generate condensate that accumulates in any drain point (e.g., tanks, filter, aftercoolers, dryers). This condensate contains lubricat- ing oil and/or substances which may be regulated and must be disposed of in accor- dance with local, state, and federal laws and regulations.

1.Set the Auto/Off lever to "Off".

2.Close the globe valve.

3.Remove the air tool or accessory.

4.Open the globe valve and allow the air to slowly bleed from the air tank until tank pressure is approximately 20 psi.

5.Close the globe valve.

6.Drain water from air tank by opening drain valve on bottom of tank.

Risk of bursting. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.

Risk of property damage. Drain water from air tank may con- tain oil and rust which can cause stains.

7.After the water has been drained, close the drain valve. The air compressor can now be stored.

NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.

Oil

Use air compressor oil only. Multi-weight automotive engine oils like 10W30 should not be use in air compressors. They leave carbon deposits on critical components, thus reducing performance and compres- sor life.

NOTE: Use 30W compressor oil or a heavy duty SAE 30W, non-detergent, SF

grade or better oil. DO NOT use multi-weight automotive engine oils, they will reduce compressor life. Under extreme winter condition use SAE-10 weight oil.

NOTE: Crankcase oil capacity is approximately 16 fluid ounces (0.47 L).

Checking

1.The oil level should be to the middle of

the sight glass (C). A

2.If needed remove oil fill plug (A) and slowly add oil until it reaches the middle of the sight glass.

Changing
1.	Remove the oil fill plug (A).
2.	Remove the oil drain plug (B) and drain	C
	oil into a suitable container.
3.	Replace the oil drain plug (B) and tight-	B
	en securely.

4.Slowly add compressor oil until the oil level is in the middle of the sightglass

(C). NOTE: When filling the crankcase, the oil flows very slowly into the pump. If the oil is added too quickly, it will overflow and appear to be full.

15 - ENG N020206