Porter-Cable N020206-NOV08-0, C7501M Problem, Cause, Correction, See Motor Pulley/Flywheel

PROBLEM	CAUSE	CORRECTION
Motor will not	Fuse blown, circuit	1. Check fuse box for blown fuse
run (continued)	breaker tripped.	and replace as necessary. Reset
		circuit breaker. Do not use a fuse
		or circuit breaker with higher
		rating than that specified for
		your particular branch circuit.
		2. Check for proper fuse. You
		should use a time delay fuse.
		3. Check for low voltage conditions
		and/or proper extension cord.
		4. Disconnect the other electrical
		appliances from circuit or
		operate the compressor on
		its own branch circuit.
Safety Valve	Pressure switch, check	Have checked by a Trained
on pump	valve, or pump could be	Service Technician.
"pops" out	in need of servicing.
Knocking Noise	Possible defect in	Operate safety valve manually
	safety valve.	by pulling on ring. If valve still
		leaks, it should be replaced.
	Defective check valve.	Remove and clean, or replace.
	Loose pulley.	Tighten pulley set screw.
	Loose flywheel.	Tighten flywheel screw.
	Compressor mounting	Tighten mounting screws.
	screws loose.
	Loose belt.	Loosen wingnut and then
		tighten wingnut until it contacts
		the washer, plus one turn.
	Carbon build-up in pump.	Have checked by a Trained
		Service Technician.
	Belt too tight.	Loosen wingnut and then
		tighten wingnut until it contacts
		the washer, plus one turn.
Excessive	Loose belt.	Loosen wingnut and then
belt wear		tighten wingnut until it contacts
		the washer, plus one turn.
	Tight belt.	Loosen wingnut and then
		tighten wingnut until it contacts
		the washer, plus one turn.
	Loose pulley.	Have checked by a Trained
		Service Technician.
	Pulley misalignment.	See Motor Pulley/Flywheel
		Alignment paragraph in the
		Maintenance section.
Squealing	Compressor pump	See Oil-Checkingparagraph
sound	has no oil.	in the Maintenance section.
	Loose belt.	Loosen wingnut and then
		tighten wingnut until it contacts
		the washer, plus one turn.

N020206 22 - ENG