Hearth and Home Technologies 7100, 9100 manual Installation of Ducting, Model

Installation of Ducting

Installation through an outside wall

Remove air deflector (used for ventless operation only). Cut appropriate-sized hole through the wall directly behind the range hood outlet (see Figure 6 ,page 7), making sure no wall studs are cut. Push range into position. From outside of the house, measure distance from the siding to the range outlet. Cut duct pipe that length, plus 1" (25mm) for overlap into outlet. Attach vent hood to pipe. Caulk the back of vent hood and around pipe where it goes through wall and into range hood outlet so caulking seals against outside siding.

Complete installation by following directions under Ventless Installation.

Installation through an attic to an outside wall

If the vent elbows are embedded in the wall, the range may be positioned as shown in Figure 6. Continue the duct through the ceiling into the attic. Terminate duct either on an outside wall just below the sofit using a vent hood or through the roof with a roof cap. Seal with caulking aroundandundercaporhood. Complete your installation by following directions under Ventless Installation.

	R ange Ho od Outlet:	19"
	3 1/4" x 1 0"
14"	83 m m x 254m m	483 m m

356 m m

31. 0"			56 "
787 m m		1416 m m
					P ower In	66 1/ 4"
						1682 m m
					(direct c on	ect)
			36 1/8"		8 ft (2.4m ) cord supplied
			917 m m		Ex haus t Hood In
					(female rec epticle)
29 3/4 "	1 1/4 "		9 ¼ "			38 1/4"
			235	m m	47 1/2"	972 m m
756 mm	32	m m
					1207 m m

			Model 7100
	1 4 7 /8 "	R ange H ood
		O ut let : 3 1 /4"x 10"		14. 0"
	3 7 8 m m		83 m m x 254 m m
				356 m m
		2 9 3 /4 "
56 "		75 6 m m		31.0"
				787 m m
142 2 m m
	G a s In le t-1 /2 N P T
			6 6 1 /4 "
	P owe r I n		16 8 2 m m
	(direct co n n ec tion )
3 6 1/8 "	8 ft (2.4m ) cord		6 2 3 /8 "
9 17 m m	pplied	E xha u st	1 5 85 m m
3 4	"	H oo d In
8 64 m m
3 3 /4" / 92 m m	29 3 /4"		2"	29 3 /4 "
			51 m m	756 m m
	7 5 6 m m
			Model 9100

8