Assembly and Installation
To fully enjoy your new range, it is important that you read this booklet thoroughly.
Note: Please check for any damage that may have occurred during shipping. In the unlikely event that you find any shipping damage, inform your dealer immediately!
The Model 7100 and 9100 Range consists of three main parts:
The Range Base
The Range Body, and
The Exhaust Hood or Cresting Assembly
Tools required for assembly:
Slot screw driver
7/16” (11 mm) wrench or crescent wrench 5/16" (8 mm) wrench or crescent wrench
(You must have a qualified gas technician install this appliance to be sure the installation codes and rules are observed.)
| 1/8"- 1/4" |
| Teflon Glider |
Teflon | Figure 1a |
Glider |
Painted section
Nickel plated section
Figure 1
Assembly of Range Base
1.Unpackage the base sections, legs and hardware package which are located in a carton fastened to the skid at rear of the range (it would be a good idea to check for any damage that may have occurred during shipping).
2.Screw the base levelling bolts (with teflon glider attached) into each of the four legs. The levelling bolts are located in the hardware package. When installing the levelling bolts, the teflon glider should extend beyond the bottom of the leg by approximately
3.Assemble base to legs using the nuts and bolts provided. For the 48" the shorter base sections are the sides and the longer sections are front and rear. (the black painted section goes to the rear, see fig. 1). For the 30" the base sections are all the same length, the black painted section goes to the rear, see fig. 1.
4.Hand tighten the nuts and bolts until the range base is completely assembled. Ensure that all base sections are installed with the lip up.
5.Adjust base sections to the most upper position and tighten up the nuts and bolts.
2
