Hearth and Home Technologies 7100, 9100 Positioning the Range, Assembly of Exhaust Hood to Range

Assembly of Exhaust Hood to

Range

See the manual entitled "Cabinet Assembly

Instructions for Gas , Electric ,Combination and Wood Stoves" which is included with the cabinet .

Positioning the Range

1.When the range is fully assembled, recheck all electrical connections especially between the exhaust hood and the back of the range. As well, check that all nuts and bolts have been tightened.

2.Ensure teflon gliders and flooring are clean, (as described in the second paragraph under "Assembly of Range Base".)

3.Caution: On flooring with very rough surfaces or deep, large grooves the appliance may have to be lifted and slowly slid into position.

4.Put both hands on the trim and carefully push the range into place, make sure floor is clear of all debris. Don't forget to plug in the main power cord and the exhaust hood power cable before the range is in its final position. See cabinet installation instructions.

5.To level the range, simply adjust the levelling screws with teflon pads located at the bottom of each leg (the ones you assembled in step 2 of "Assembly of Range Base"). Using a 5/16 (8 mm) open- end wrench turn the adjusting screw clockwise to raise up the corner, and counter-clockwise to lower the corner. (Don't forget the teflon glider should extend beyond the bottom of the leg by approximately 1/8"-1/4")

6.Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the flooring. When the range is in position and levelled, you may want to place coasters under the teflon gliders of each leg, to protect the floor. Remove the coasters when moving the range for cleaning or servicing.

4