8Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the firebox.

B. Top and Rear Vent Conversion

KIT CONTENTS: Rear vent grill; .096 NG orifice; .059 LP orifice; Rear Vent Cover Plate, Top Grill Cover Plate

TOOLS REQUIRED: Power drill; #2 Phillips bit; 5/32 in. Allen wrench; 5/8 in. open end wrench; high-temp silicone sealant (optional.)

1. Convert to Rear Vent

At the REAR of the appliance:

Outer Flue

Damper Adjustment

Cover

Plate

Rear

Access

Plate

Figure 8.2 Remove the rear outer flue cover plate (with the damper adjustment plate attached). Ensure that the gaskets and grommets stay in place.

Remove the inner flue cover plate and set aside.

At the TOP of the appliance, with exceptions noted:

Figure 8.1 Remove rear access plate on the back shield and

discard.Figure 8.3 Lift out the cast insert piece on top of the appli- ance.

CAUTION

Sharp Edges

Wear protective gloves and safety glasses during installation.

Remove the outer flue collar and inner collar adapter, and set aside. Ensure that the gasket is intact; if not, high temperature silicone can be used as an alternative to gasket replacement as indicated in Figure 8.4 on the next page. Remove the screws retaining the inner flue collar.

Lift out the inner flue collar with damper in place.

NOTE: In the Commonwealth of Massachusetts, the word damper shall be replaced with the words flue restrictor.

September 1, 2008

Quadra-Fire · Sapphire · 250-7233H

Page 29

Page 29
Image 29
Hearth and Home Technologies SAPPH-D-CSB Appliance Setup, Remove Shipping Materials, Top and Rear Vent Conversion