Hearth and Home Technologies EM-415H owner manual Installing an ST375 Square Termination Cap

•For installations utilizing an ST375 Square Termination Cap the last chimney section must not be more than 4-1/2 in. (114 mm) below the chase top. See Figure 6.7.

•For installations utilizing an TCT375 Terra Cotta Cap the last chimney section must be between 7 in. (178 mm) below the chase top and 2 in. (51 mm) above. See Figure 6.9.

		Flashing Collar
Cap Standoff			2 in. (51 mm) min.
					4-1/2 in.
1-1/2 in.
(38 mm) min.				(114 mm)
overlap	Top of Pipe					max.

1-1/2 in. (38 mm) min. overlap

{

Top of Pipe

The last section of pipe must stop between the distances given below.

2 in. (51 mm) above top of the chase.

7 in. (178 mm) below top

of the chase.

Figure 6.7 Installing an ST375 Square Termination Cap

Figure 6.9 Installing a TCT375 Terra Cotta Cap

•For installations utilizing a TS345/TS345P Square Termination Cap, the uppermost chimney section must not be more than 3 in. (76 mm) below the chase top. See Figure 6.8

Flashing

Collar2 in. (51 mm)

min.

•For chase installations you can use a TR344 Round Termination Cap, a TR342 Round Telescoping Termination Cap, an ST375, TS345 or TS345P Square Termination Cap, or a TCT375 Terra Cotta Termination Cap.

•For installations utilizing a European Copper Series Termination Cap, See Figure 6.10.

•Install termination caps following instructions provided with them.

		3	in.
1-1/2 in.
		(76 mm)
(38 mm)	Top of Pipe
		max.
min.
overlap

Figure 6.8 Installing a TS345/TS345P Square Termination Cap

Cap Base

bracket (8)

screw (8)*

chimney top

chase top

(metal or masonry) SL pipe inner flue

(cap inner flue)

2 - 6 in. (51-152 mm)

2 in. (51 mm) typical

Figure 6.10 Installing a European Copper Series Termination Cap (CT3-King shown)

Heat & Glo • EM-415/EM-415H • 31317 Rev Q • 10/06 23