Hearth and Home Technologies SL-350TRS-IPI Top Vent Vertical Termination Two 90º Elbows

2.Top Vent - Vertical Termination - (continued) Two 90º Elbows

V1 Minimum		H1 Maximum		H1	Maximum		V2	V1 + V2 Minimum
		SL-350TRS-D		SL-550TRS-E, SL-750TRS-E			*	*
90º Elbow		1-1/2 ft.	457 mm	1 ft.		305 mm	*	*
1/2 ft.	152 mm	2 ft.	610 mm	2 ft.		610 mm	*	*
1 ft.	305 mm	2-1/2 ft.	762 mm	2-1/2 ft.		762 mm	*	*
2 ft.	610 mm	4 ft.	1.2 m	4 ft.		1.2 m	*	*
3 ft.	914 m	6 ft.	1.8 m	6 ft.		1.8 m	*	*
4 ft.	1.2 m	8 ft.	2.4 m	8 ft.		2.4 m	*	*
5 ft.	1.5 m	15 ft.	4.6 m	15 ft		4.6 m	*	*

H1 Maximum= 15 ft. (4.6 m)

V1 + V2 + H Maximum = 40 ft. (12.2 m)

*No specific restrictions on this value EXCEPT V1 + V2 + H1 CANNOT exceed 40 ft. (12.2 m)

V2

Note: Use SL-D Series components only.

H1

V1

Note: There MUST be a 25% reduction in total H when using flex vent except when using the simple up and out installation (see Figure 5.3).

Figure 5.8

Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/07 19