Manuals / Hearth and Home Technologies / Household Appliance / Indoor Fireplace

Hearth and Home Technologies SL-550TV-IPI-E owner manual Finishing, A. Mantel and Wall Projections

Models: SL-950TV-IPI-E SL-550TV-IPI-E SL-750TV-IPI-E

1 48

Download 48 pages 49.26 Kb

Page 31

13 Finishing

13 Finishing

A. Mantel and Wall Projections

WARNING! Risk of Fire! Comply with all minimum clear- ances as speciﬁed. Framing closer than the minimums list- ed must be constructed entirely of noncombustible materi- als (i.e., steel studs, concrete board, etc.) Failure to comply could cause ﬁre.

Combustible Mantels

	CEILING
	12
	11
	10
	9
7	8	32
7		32
6
5	12 13
4	12 13

TOP VIEW

2-7/8 IN.

MINIMUM

Note: Clearance from opening Alcove/Mantel leg.

1/2 IN.

MINIMUM

3FT.

MAXIMUM

3					7		8	9	10 11
3									10 11


			6
		5
4		5

TOP OF HOOD OR FIREPLACE OPENING

Note: All measurements are in inches.

Figure 13.1 Minimum Vertical and Maximum Horizontal

Figure 13.3 Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening)

Dimensions of Combustibles

	1/2 in.
3-1/2 in.	SHEETROCK

NON-COMBUSTIBLE

BOARD SHIPPED

WITH APPLIANCE

TOP VIEW

5-3/8 IN.

MINIMUM

Note: Clearance from opening Alcove/Mantel leg.

3 IN.

MINIMUM

UNLIMITED

1/2 in.

Figure 13.4 Non-Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening)

NON-COMBUSTIBLE ZONE

Figure 13.2 Minimum Vertical and Maximum Horizontal

Dimensions of Non-Combustibles

Heat & Glo • SL-550 / 750 / 950TV-IPI-E • 2119-900 Rev. H • 11/08

31

Image 31

Hearth and Home Technologies SL-550TV-IPI-E, SL-750TV-IPI-E Finishing, A. Mantel and Wall Projections, Combustible Mantels

Contents

What to do if you smell gas Models SL-550TV-IPI-E SL-750TV-IPI-E SL-950TV-IPI-EOwner’s Manual Please retain this owner’s manual for future reference A. CongratulationsHomeowner Reference Information Read this manual before installing or operating this appliance3 Maintenance and Service Table of ContentsSafety Alert Key Installer GuideC. Clean the Appliance D. Accessories 14 Appliance Setup15 Troubleshooting A. Remove Glass Assembly B. Remove the Shipping MaterialsHearth & Home Technologies LIMITED WARRANTY B. Limited Lifetime WarrantyCONDITIONS, EXCLUSIONS & LIMITATION OF LIABILITY B. Limited Lifetime Warranty continued C. BTU Speciﬁcations 1 Listing and Code ApprovalsA. Appliance Certiﬁcation B. Tempered Glass SpeciﬁcationsG. Electrical Codes D. High Altitude InstallationsE. Non-Combustible Materials Speciﬁcation F. Combustible Materials Speciﬁcation2 Operating Instructions User Guide A. Gas Fireplace SafetyB. Your Fireplace E. Decorative Doors and Fronts F. Fixed Glass AssemblyG. Remote Controls, Wall Controls and Wall Switches C. Fan Kit optional1. Turn off all electric power to the appliance I. Lighting Instructions IPIFinal inspection by FOR YOUR SAFETY READ BEFORE LIGHTINGSOLUTIONS K. Frequently Asked QuestionsJ. After Fireplace is Lit ISSUERemote Control 3 Maintenance and ServiceA. Maintenance Tasks-Homeowner Glass CleaningLogs B. Maintenance Tasks-Qualiﬁed Service TechnicianGasket Seal and Glass Assembly Inspection VentingFigure 3.2 IPI Pilot Flame Patterns Either cobrahead or SITFRAMING HEADED OFF IN CEILING JOISTS SECTION 8.B OPTIONAL WALL SWITCH Getting StartedA. Typical Appliance System Installer GuideC. Tools and Supplies Needed B. Design and Installation ConsiderationsD. Inspect Appliance and Components E. Negative Pressure Model 5 Framing and ClearancesA. Selecting Appliance Location F AC. Clearances B. Constructing the Appliance ChaseMINIMUM FRAMING DIMENSIONS Figure 5.4 Non-Combustible Zone D. Mantel and Wall ProjectionsCombustible Mantels Note All measurements are in inchesDO NOT pack air space with insulation or other materials 6 Termination LocationsA. Vent Termination Minimum Clearances Fire Risk Maintain vent clearance to combustibles as speciﬁedVent this appliance directly outside 7 Vent Information and DiagramsA. Vent Guidelines B. Vent System ConﬁgurationC. Vertical Penetration Framing 8 Vent Clearances and FramingA. Pipe Clearances to Combustibles B. Wall and Ceiling Penetration FramingC. Securing and Leveling the Appliance A. Installing Outside Air Kit Damper Assem- bly9 Appliance Preparation B. Gas and Electrical ConnectionsC. Securing Vent Sections 10 Installing Vent PipeA. Assembly of Vent Sections D. Install Attic Insulation ShieldC. Gas Connection 11 Gas InformationA. Fuel Conversion B. Gas PressureB. Intelliﬁre Ignition System Wiring A. Wiring RequirementsC. Optional Accessories Requirements D. Electrical Service and RepairBROWN 110 VAC to wall switch E. Junction Box InstallationF. Wall Switch Installation for Fan Optional NOTICE DO NOT wireDimensions of Non-Combustibles 13 FinishingA. Mantel and Wall Projections Dimensions of CombustiblesB. Facing Material D. Accessories 14 Appliance SetupA. Remove Glass Assembly C. Clean the AppliancePlacing the Lava Rock E. Lava Rock, Mineral Wool/Ember PlacementLog Set Assembly LOGS-550-E, 750-E, 950-E F. Install the Log AssemblyModel SL-550TR-E, 750TR-E, 950TR-E SL-550TV-E, SL-750TV-E, SL-950TV-E Log #3 Locate the pin hole on the underside of log #3. Mate the pin hole with the shoulder screw located on the burner top. Push the left end of log # 3 toward the back of the ﬁrebox until it touches the lava rock retainer J. Install Hood G. Fixed Glass AssemblyH. Install the Mesh I. Install Trim and/or SurroundA. Incorrect wiring 15 TroubleshootingA. Intelliﬁre Ignition System SymptomWith ﬁxed glass assembly in place, verify that ﬂame is en Intelliﬁre Ignition System - continuedSymptom Verify all connections to wiring diagram in manual. VerifyGAS LINE ACCESS A. Appliance Dimension Diagram16 Reference Materials Figure 16.1 Appliance DimensionsService Parts Diagram Log Set AssemblyB. Service Parts SL-550TV-IPI-EStocked Service Parts ListSL-550TV-IPI-E at DepotService Parts Diagram Service PartsSL-750TV-IPI-E Log Set AssemblyStocked Service Parts ListSL-750TV-IPI-E at DepotService Parts Diagram SL-950TV-IPI-ELog Set Assembly Service Partsat Depot SL-950TV-IPI-EStocked Service Parts ListStocked IPI Valve AssemblyService Parts SL-550 / 750 / 950TV-IPI-EDO NOT DISCARD THIS MANUAL C. Contact Informationand maintenance installation and operation