Hearth and Home Technologies TRUE-36 Electrical Service and Repair Junction Box Installation

D. Electrical Service and Repair

WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105º C rated wire. Wire must have high temperature insulation.

E. Junction Box Installation

If the box is being wired from the INSIDE of the appliance:

•The junction box is accessible through the front left column if finishing materials have not been installed. The junction box is also accessible through the firebox access panel. See Figure 12.2.

•Remove the screw attaching the junction box/receptacle to the outer shell, rotate the junction box inward to dis- engage it from the outer shell. See Figure 12.3.

•Pull the electrical wires from outside the appliance through the opening into the valve compartment and secure wires with a Romex connector. See Figure 12.3

•Make all necessary wire connections to the junction box/ receptacle and reattach the junction box/receptacle to the outer shell.

NOTICE: DO NOT wire 110 VAC to wall switch.

Romex
Connector	WHT
	BLK
	WHT
14/2WG	BLK

GRN wire inside box

Copper ground attached to GRN screw with GRN wire

Figure 12.3 Junction Box Detail

	ACCESS THROUGH LEFT COLUMN	ACCESS THROUGH FIREBOX
	(Prior to installation of non-combustible board)	(After installation of non-combustible board)
		GASKET
		COVER
Figure 12.2 Junction Box Access
46	Heat & Glo • TRUE-36, TRUE-42, TRUE-50 • 2282-900 Rev. D • 8/12