2 Getting Started
A. Design & Installation Considerations
Heat & Glo direct flue gas stoves are designed to operate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside. No additional air source is required.
CAUTION
Check building codes prior to installation.
•Installation MUST comply with local, regional, state and national codes and regulations.
•Consult local building, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.
When planning an installation, it is necessary to determine the following information before installing.
•Where the gas stove is to be installed.
•The flue system configuration to be used.
•Gas supply piping.
•Electrical wiring.
B. Inspect Appliance & Components
WARNING
Inspect gas stove and components for damage. Damaged parts may impair safe operation.
• Do NOT install damaged components.
•Do NOT install incomplete components.
•Do NOT install substitute components.
Report damaged parts to dealer.
•Carefully remove the gas stove and components from the packaging.
•Remove door and set aside on protective surface.
•Remove log set and component pack from firebox.
•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
•Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure safety and benefit.
WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged gas stove or flue system component.
•Modification of the gas stove or flue system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the gas logs or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
Heat & Glo • | 5 |
