D. Optional Accessories Requirements
•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.
•To connect optional accessories, the supplied cord as- sembly should be used. See attached Figure 10.4 for a wiring diagram for a blower or remote.
Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.
•Plug the cord into a convenient outlet.
•Must use cord supplied.
•An IntelliFire Plus™ Wireless Controls or
•A standard ON/OFF switch is compatible.
WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with type 105° C rated wire. Wire must have high temperature insulation.
PLUG
120V EXISTING OUTLET
NOTE: IF ANY OF THE ORIGINAL | BLOWER |
| |
WIRE AS SUPPLIED WITH THE |
|
APPLIANCE MUST BE REPLACED, |
|
IT MUST BE REPLACED WITH TYPE |
|
1050 C RATED WIRE. |
|
NOTE: USE ZIP TIES TO RESTRAIN |
|
THE LOOSE WIRES UNDERNEATH |
|
THE APPLIANCE AND KEEP THEM |
|
AWAY FROM THE BLOWER WHEEL | SENSOR SWITCH |
(FAN BLADES). | |
| TEMPERATURE |
TO VALVE BRACKET (GROUND)
GREEN
SPEED CONTROL
(RHEOSTAT)
ORANGE
TO VALVE
BROWN 
BLACK
RED
VARIABLE SPEED
CONTROL
BLK
BLK BLK
BLK
TEMPERATURE
SENSOR SWITCH
PLUG INTO 120V
EXISTING OUTLET
DC REGULATOR
RECEPTACLE
BLOWER
RECEPTACLE
WHT BLK GRN GRN
BLK BLK
BLK BLK
GRN GRN
WHT BLK
BLOWERS
Figure 10.4 Fan Wiring Diagram
28 | Heat & Glo • |
