![](/images/new-backgrounds/1126581/1265815x1.webp)
Remote Control
Note: One remote control is able to independently operate two receiver units.If more than two receiver units, operating independently, are desired, additional remote controls will need to be purchased.
1.RemoveTab from Battery Chamber.Remove cover from back of transmitter. Gently pull tab out of battery chamber. Slide cover onto transmitter.
Note: To independently operate a second receiver unit using a single remote control, make sure the second set of code switches (Right Side) and the code switches on each receiver match (see Code Settings section).
•Left Side - Set left side code switches.
•Right Side - Set right side code switches.
| Right Side DIM | ENGLISH |
Left Side DIM | Right Side ON | |
| ||
|
|
Battery Chamber
(Type A23)
ON DIP
1 2 3 4
ON DIP
1 2 3 4
Tab
Battery Cover
Left Side ON | Right Side OFF |
| |
Left Side OFF | |
| Function Controls |
Important: Wait 1 to 2 seconds after you press a transmitter button before you press it again to allow the transmission to be completed.
Rear View of Remote Control
2.Remote Control Functions. The three buttons on the left side of the remote will operate one or more receiver units with matching code settings. The three buttons on the right side of the remote will operate a second set of one or more receiver units.
•ON: Turns on any receiver unit set to the same code as this remote control.
•OFF: Turns off any receiver unit set to the same code as this remote control.
•DIM: Activates the DIM feature for any receiver unit set to the
same code as this remote control. Note: Pressing the DIM button steps through five brightness levels.
3 4
5
4
2 1
2
3
Note: If light does not turn on or intermittently turns on and off when transmitter buttons are pushed, see Troubleshooting Guide.
Optional Car Visor Clip (Included)
The remote control includes an optional car visor clip for added convenience that may be installed.
1.To attach car visor clip to remote control (if desired) push it into slot on rear of remote unit until it snaps into place.
2.To remove car visor clip, insert a small,
| |
Screwdriver | Optional |
| |
| Visor Clip |