![](/images/new-backgrounds/1126581/1265817x1.webp)
indoor and outdoor
Wireless Motion Sensor
Installing Indoor Motion Sensor Using Optional
Mounting Bracket
Indoor Wireless Motion Sensor
Outdoor Wireless
Motion Sensor
Features:
•No wiring required.
•Up to 70 feet sensing range, 180° Coverage (Outdoor).
•Up to 30 feet sensing range, 150° Coverage (Indoor).
•Adjustable sensitivity.
•Day/Night or Night only operation.
•Test mode.
•Uses 2 AA batteries.
•Wall or eave mount (Outdoor).
•Can be mounted directly to wall or with mounting bracket (included) (Indoor).
•Controls receivers up to 100 feet away.
Note: Mount the indoor motion sensor so that it can be angled up or down to give you the desired coverage above the floor level.
1.Attach ball mounting bracket to rear of motion sensor. The ball mounting bracket is designed to mount to the rear of the sensor in three possible directions depending upon the installation requirements. To attach the ball mounting bracket, follow the steps shown below:
•Determine the best mounting position of the sensor for the coverage desired.
•Determine the best location of the wall mounting bracket.
•Insert the tabs on the ball mounting bracket into the tab slots on the rear of the sensor that best align the sensor with the wall mounting bracket.
•Remove the batteries.
•Using a
Select Night or 24 Hour Mode
These sensors are able to detect motion day and night or night only. To set the detection mode, remove battery compartment
Ball Mounting
Rear of Sensor
cover by sliding the cover down. Remove batteries if necessary. Slide the DETECT switch to either the DAY/NIGHT or NIGHT ONLY position. Replace battery compartment cover by reversing the above instructions.
Installing Batteries
•Before mounting outdoor motion sensor, remove battery compart- ment cover by sliding the cover down.
•For indoor motion sensor, install batteries after sensor is in- stalled.
Install 2 AA batteries according to polarity markings inside the battery compartment. Replace battery compartment cover by reversing the above instructions.
Bracket Screw
| Tab Slots | |
| Tab | |
Ball Mounting | Swivel | |
Ball | ||
Bracket | ||
Mount | ||
|
Detect
Control
DAY NIGHT
NIGHT ONLY
|
|
|
|
|
|
1 2 3 4 |
| DETECT |
CODES |
|
|
CODE | DETECT | |||
|
|
| (MINUTES) |
|
| DAY | NIGHT | 5 1 TEST |
|
1 2 3 4 NIGHT | ONLY | MIN | MAX |
Attaching Ball Mounting Bracket to Indoor Motion Sensor
(Vertical Installation Shown)
2. | Place sensor mounting bracket against surface to be mounted |
| on and mark hole locations with pencil or center punch. |
3. | Using a 2.5 mm (0.1") drill bit, drill two pilot holes for mounting |
| screws. If not mounting directly to wood or wood stud, drill 5 |
| mm (0.2") pilot holes and use the included wall anchors. |
4. | Attach indoor motion sensor mounting bracket to a sturdy object |
| (i.e. wall, ceiling, post, etc.) using two screws provided. Make |
| sure unit has an unobstructed view. Note: Attach mounting |
| bracket vertically if connecting to a curved surface such as a |
Outdoor Motion Sensor | Indoor Motion Sensor |
(Rear View) | (Front View) |
Battery Compartment
post. |
5. Install motion sensor to mounting bracket.Using a |
screwdriver, loosen the clamp screw on the mounting bracket. |
Insert swivel ball mount on sensor into mounting bracket socket |